Conventional Cabinets

DOWNLOAD PDF CABINET SPEC SHEET  for BD Models

DOWNLOAD Spec Sheet for Drop-In Models

DOWNLOAD Spec Sheet for BS Models

This table shows the number of actual tubs this line of cabinets will hold when not using tub skirts

See this video of NEW can skirt systems for use with conventional cabinets  

 tub capacity
IMPORTANT NOTES:NSF STANDARDS REQUIRE CABINET TO BE INSTALLED WITH CASTERS, 6” LEGS, OR SEALED TO THE FLOOR WITH AN NSF APPROVED SILICONE SEALANT AT THE TIME OF INSTALLATION.      

SPECIFICATIONS

  • One piece 22 ga. 304 stainless steel, all corners welded (no corner pieces or raw edges, ever).
  • Galvanized steel reinforced sub-top beneath the stainless top, Anti-condensate heater wires on galvanized sub-top to prevent condensation on cabinet top.
  • 24 ga stainless steel interior, Optional 22 ga. 304 stainless steel exterior.
  • Copper tubing cold wall type evaporator attached to liner wall.
  • Forced air condensing unit (clog free design on all BD models) on glide-out base for efficient operation and built-in applications.
  • Base of cabinet to be constructed of 16 ga. Galvanized steel.
  • Poured-in place urethane foam insulation with a minimum "K" factor of .13.
  • Lids to be stainless steel top with poured urethane foam insulation and hinged in the center with rubber handles.
  • Freezer lid gaskets to be of a molded, one piece, high impact grade ABS plastic.
  • Cabinet to be equipped with a 7-ft power cord, 3 wire, grounded, dead front construction.
  • Unit to be NSF & ETL approved.

 

Specifications

BD4

BD6

BD8

BD10

BD12

BD14

BS2

BS4

SHIP WT.

225

275

315

375

430

460

175

240

CuFt CAPACITY

8.0

13

17.5

22.5

27.5

29.5

4.8

10.5

NBR FACINGS

5

8

11

14

17

18

2

5

TOTAL NBR TUBS

7

13

19

25

31

33

4

9

COMPRESSOR

1/3 hp

1/3 hp

1/3 hp

1/3 hp

Sm 1/2 hp

Sm 1/2 hp

1/5 hp

1/5 hp

AMPS

8

8

8

8

11

11

5

5

ELECTRIC

115 v.

115v.

115v

115v

115v

115v

115v

115v